Then, click on the Network and Sharing Center before choosing the icon that’s next to Connections. The settings of your network on your system can cause the issue to occur. Third-party software. (The icon says "Not connected - No connections are available) Going into Control Panel/Network and Internet/Network Connections, it then says "Local Area Connection Network cable unplugged". In my Win7 installation, my network shows up as "Network 2" when I mouse over the Internet Connection icon in the Application Tray (lower right-hand corner). This computer will be used as the Master Browser on your network. The Ethernet cable socket on your laptop computer may be on either side or the back of the computer. If your IP address configuration is incorrect, it can cause the issue. My laptop has a gigabit port on it, and so do my sons’ laptops. Network settings. It has been checked with different cables but the problem persists. When connected, it shows the name of the current network. You can also access devices directly by typing their IP address or hostname in the address bar at the top of the File Explorer window.. Configuring Your Firewall to Allow File and Printer Sharing So I tried my laptop and one of my sons’ laptops to try to eliminate all other possibilities. To see your active network connections in Windows, start by selecting Settings in your Start menu and going to Ethernet. My internet will only work through ethernet cable not wireless ... but the result shows that cable is unplugged and you are connected via wifi. When your system connects to a network, an address is assigned to the computer called IP address. We just upgraded our home internet to the fastest fibre connection available, 100 Mbps, but even with a compatible router (Linksys EA4500) speedtest.net shows download speeds of only … If you have only computers with Win 10 1709 and newer in your local network (see the table of SMB versions), and you still want to use the Computer Browser, you must enable the SMB v1.0 protocol (it is unsafe!) Right-clicking on one will give you the option to disable or enable it. I recently got a Dell inspirion 5000 series but whenever I connect an ethernet cable it will disconnect from the internet for a second and reconnect regularly. Try a known-good computer. Your all good for this! I have the same problem, no internet unless I have an ethernet cable plugged in, but whenever I go to Network Connections, It only shows Bluetooth Network Connection 2 and Ethernet… Wifi is ok. Basically what happened before: After updating to Windows 10, my computer was not showing any network options. If they couldn’t connect at gigabit speeds with a known-good cable, it’s either a bad port on the switch, or a bad cable run in the wall. Find your broadcom ethernet and right click to select update driver software 4. On the next page, click on Details to display information about your network connection. This does not solve your lack of WiFi reception, but it does show your modem is receiving a signal and it allows you to get onto the Internet on an emergency basis. After its done go into properties>power management> and uncheck Allow the computer to turn off this device when power is low. No big deal, but I only have one network, and it used to say "Network" at one time. Choose browse my computer for driver software 5. An old laptop works fine. 3. Once network discovery has been enabled, you should be able to see other computers in the Networks tab—but only if those devices have network discovery enabled, too. on at least one computer. Choose the folder with the driver in it, it should be a .sys file 6. It will be on the back of a desktop computer.